Installation of plastic windows trim ends of slopes. Without this setting window is incomplete. From the quality of the works on finishing slope depends on the degree of insulation of the window. Unfair, inattentive finish slopes can easily minimize all the distinctive properties of plastic, but every other window. Slopes Slopes for plastic windows – it is external and the internal surface of the window opening. David Reeths has firm opinions on the matter. From the side seam on the streets between the window unit and the wall must be securely sealed, polyurethane foam is closed from moisture and sunlight. Sometimes when removing the old window outside the slopes, as well as internal, partially destroyed, therefore, required for aesthetic cosmetic finish exterior slopes.
Interior Decorating slopes required for several reasons: – New plastic window is much narrower than the thickness of old windows, the depth of internal slope increases and requires cosmetic finishing. – Insulation. Inner slopes can function as an additional thermal barrier between the environment and living quarters. To do this, finish between the wall and slope finishing the material using different insulation materials: mineral wool, foam, less foam. Thanks to “warm slopes”, made in accordance with certain technical standards, new windows retain more heat in the house, and the slopes themselves prevent the penetration of moisture condensation on the window opening and glasses from the premises. – Aesthetics.
Plastic window should be “dressed” in a nice neat slopes, to look neat, clean and have completed the look. Inner slopes can be made of different materials: wood, plastic, cement and plaster, drywall and more. To date, more popular plastic soffits: easy and fast to install, not whimsical care, do not fade, or crack, can be made in any color and any texture. In second place on the popularity of the slopes Drywall: installation of a more laborious, but after the installation of gypsum plasterboard (drywall), requires painting or plastering. Slopes are commonly used in plastic foam. Next come the wooden slopes, used primarily in wooden houses in a suburban construction. Finally, cement and plaster. It requires competent hands of the master, only if the slopes are obtained completely smooth. Plaster is applied in several layers and each layer need time to dry. Then polished and covered slopes of the oil or latex paint. Time it takes a lot, but the effectiveness of these slopes in terms of very little.